<html>
<font size=3>At 04:57 PM 07/13/2001 -0500, you wrote:<br>
<blockquote type=cite cite>Jon..... hope you get this... I THINK I'm
putting it in the right spot. I<br>
know that 1:30-2:00 is right for grand stuff ( shanks..), but really I
am<br>
looking at the part and seeing where the seam won't be affected too
much.<br>
You have some "clock settings" for me to double check??<br>
<br>
This is my first action trying this rebushing method... Hope to
HELL I'm<br>
doing it right. I have been consistant in where I have been placing it
on<br>
all the parts.. depending on the part... uh-oh.... </blockquote><br>
I am not really fluent at replacing bushings. AlI know is that placing
the seam at 12:00 is not good.<br>
<br>
On the few bushings that I have had to replace, I place the seam the area
you mentioned.<br>
<br>
Bill Spurlock has info describing the proper procedure, if I were to do a
set; I would get the tools you have<br>
and the info from Bill (did Renner supply Bill's info with the
tools?)<br>
<br>
You've gone this far, rebush the jacks.<br>
<br>
Jon Page</font></html>