<HTML> <HEAD> <TITLE>Re: [CAUT] Pin Driver</TITLE> </HEAD> <BODY> On 1/21/05 12:35 PM, "Don McKechnie" <dmc= kech@ithaca.edu> wrote: <BLOCKQUOTE>Avery, Here is the company page for the driver: http://www.danairinc.com/palmnailer.html I have been considering this tool as well and interested in hearing what ot= her have to say. There was a thread on this a while back I believe. Don </BLOCKQUOTE>Andre and Christian Bolduc said in= their all day pinblock class at Nashville that they use one (like others, t= hey had their own “socket” made for a standard air chisel). They= describe using it to enable a stringing job to be done in under 4 hours: in= stall all tuning pins first (shallow), insert wire from a fixture that holds= all sizes (and straightens the wire as you pull it out) and make coils in p= lace, then do final pin driving with the air hammer (with a spacer attached = to limit depth, so all are driven equally). Regards, Fred Sturm University of New Mexico </BODY> </HTML>