<html>
<body>
<font size=3><br>
Hi Mark,<br>
Size with CA it works fine. We replace pins regularly. I push
the new pins in, on the drill press, with the quill set to the right
depth. 'Use a piece of 1/4" rod with a dimple drilled in the
end of it. Works great every time.<br>
Regards roger<br><br>
<br><br>
At 05:44 PM 8/30/2004, you wrote:<br>
<blockquote type=cite class=cite cite="">we're having to replace a set of
nicked .146" front-rail pins and have<br>
replacements on hand, however, the new ones are a loose fit in the
original<br>
holes.<br><br>
i.e.: not wobbly, but they can be pushed in and turned with bare
hands.<br><br>
I was thinking of pre-sizing the holes with hide glue ... any<br>
cautions/suggestions?<br><br>
thanks,<br>
Mark Cramer,<br>
Brandon University<br><br>
_______________________________________________<br>
caut list info:
<a href="https://www.moypiano.com/resources/#archives" eudora="autourl">https://www.moypiano.com/resources/#archives</a>
</font></blockquote></body>
</html>