<html>
<body>
Lance -<br>
There may be more to it than you think. While you don't appear to intend
to do any spray finishing, you are concerned about the nuisance impact of
the materials you mentioned. You may be conscientiously attempting
to avoid a problem while walking into another one. You need to be
sure you're not in violation of any zoning ordinances by venting to the
roof. You should probably talk to a ventilation engineer in the
area. Also, if your perforating the roof membrane you need to be very
careful about water leaks. Good luck.<br><br>
David Skolnik<br><br>
<br><br>
At 07:02 PM 12/7/2003 -0600, you wrote:<br><br>
<blockquote type=cite class=cite cite><font face="arial" size=2 color="#000080">I
will be working in an area with lots of people around/near and need
ventilation. It is a work area in a retail strip. It will
have to be a roof installed vent. Thanks.<br>
</font><br>
<font face="arial" size=2 color="#000080"> <br>
</font><br>
<font face="Times New Roman, Times" color="#000080">Lance
Lafargue</font>, RPT<br>
<br>
<font face="Times New Roman, Times" color="#000080">LAFARGUE PIANOS<br>
</font><br>
<font face="Times New Roman, Times" color="#000080">New Orleans Chapter,
PTG<br>
</font><br>
<font face="Times New Roman, Times" color="#000080">985.72P.IANO<br>
</font><br>
<font face="Times New Roman, Times" color="#000080">lancelafargue@bellsouth.net<br>
</font><br>
<font face="arial" size=2 color="#000080"> <br>
</font><br>
<font face="tahoma" size=2>-----Original Message-----<br>
<b>From:</b> caut-bounces@ptg.org
[<a href="mailto:caut-bounces@ptg.org" eudora="autourl">mailto:caut-bounces@ptg.org</a>]
<b>On Behalf Of </b>Erwinspiano@aol.com<br>
<b>Sent:</b> Sunday, December 07, 2003 2:43 PM<br>
<b>To:</b> caut@ptg.org<br>
<b>Subject:</b> Re: Shop ventilation<br>
</font><br>
<font face="Times New Roman, Times"> <br>
</font><br>
<font face="arial" size=2>In a message dated 12/7/2003 9:08:10 AM Pacific
Standard Time, mbmcmillan@shaw.ca writes:<br>
</font>
<dl><br>
<dd><font face="arial" size=2>12/7/03 6:48 AM, Lance Lafargue at
lancelafargue@bellsouth.net wrote:<br>
</font><br>
<dd><font face="arial" size=2>List, <br><br>
<dd>Can anyone help me with ventilation solutions? I have a new
12x15 workspace and I will be using lacquer to harden hammers, some light
aerosol spraying of lubricants, lacquer, etc., and need to run a simple
vent out of a commercial roof to keep the smell/toxins out of other rooms
adjacent. I thought several of you likely had experience with
this. Thanks! <br><br>
<br><br>
</font>
<dd>Lance Lafargue<font face="arial" size=2>, RPT <br><br>
</font>
<dd>LAFARGUE PIANOS<font face="arial" size=2> <br>
</font><br>
</dl><font face="arial" size=2> <br>
</font><br>
<font face="Times New Roman, Times" size=4 color="#000040">
Hey Lance<br>
</font><br>
<font face="Times New Roman, Times" size=4 color="#000040">
Open the window? Low Tech Cheap. Apply the lacquer & run.<br>
</font><br>
<font face="Times New Roman, Times" size=4 color="#000040">
Dale</font></blockquote></body>
</html>