<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN"> <html> <head> <title></title> </head> <body> I have been bothered by the spread of germs on keys, so I have been using HandiWipes and drying the keys with Swiffers.  Very fast and leaves no film.  I carry Swiffers for dusting.   Yesterday I tried Otto Keyes suggestion about using a chisel on the side of the blacks to clean the gunk.  I'd have to say it worked the best I've seen.  Over the years I've tried all the other methods people have mentioned, except the one mentioned below.  Sounds like using "Udderly Smooth" could be a "moo-ving" experience.   Tim Coates University of South Dakota University of Sioux Falls Wapin Company LLP Jim Kinnear wrote: <blockquote type="cite" cite="mid002401c371c9$44bb32f0$0201a8c0@DAD"> <pre wrap="">I have been using some stuff called Udderly Smooth, available at Walmart. It is actually what farmers use, as the name suggests, for keeping teats in order, and it works GREAT on ivory .. go figure . . Jim Kinnear ------------------ The early bird may get the worm, but the second mouse gets the cheese. ----- Original Message ----- From: "Alan McCoy" <a class="moz-txt-link-rfc2396E" href="mailto:amccoy@mail.ewu.edu"><amccoy@mail.ewu.edu></a> To: "College and University Technicians" <a class="moz-txt-link-rfc2396E" href="mailto:caut@ptg.org"><caut@ptg.org></a> Sent: Tuesday, September 02, 2003 4:10 PM Subject: RE: finger gunk poll </pre> <blockquote type="cite"> <pre wrap="">I tried a new magic potion today. VM & P Naptha. Worked very well, didn't remove any stain, dries fast and clean. It just dissolves the gunk, which ends up in the cloth, and dries. Fumes are not bad. Today's quiz: Why is a Steinway monkey called a monkey? Alan McCoy </pre> <blockquote type="cite"> <pre wrap="">-----Original Message----- From: <a class="moz-txt-link-abbreviated" href="mailto:caut-bounces@ptg.org">caut-bounces@ptg.org</a> [<a class="moz-txt-link-freetext" href="mailto:caut-bounces@ptg.org">mailto:caut-bounces@ptg.org</a>]On Behalf Of Jim Harvey Sent: Monday, August 11, 2003 7:27 PM To: <a class="moz-txt-link-abbreviated" href="mailto:caut@ptg.org">caut@ptg.org</a> Subject: Re: finger gunk poll This is essentially a summary of previous replies, with personal variations. I was going to reply earlier, but someone threw me off by discussing what sounded like key TOP cleaning. Assuming we're talking about the key SIDES... Starting with the dry, undisturbed keystick that contains finger gunk, aka 'cooties'; - use an old-fashioned single-edge razor blade, with or without a </pre> </blockquote> </blockquote> <pre wrap="">holder, </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">and positioned either straight down (dulls faster), or at a slight </pre> </blockquote> </blockquote> <pre wrap="">angle. </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">The idea is to 'drag' scrape, not cut, so while grain direction should </pre> </blockquote> </blockquote> <pre wrap="">be </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">observed, it's not that critical on most keysets. This removes the crustaceans that grow on top of the wood. The blade is also effective at the keystick and sharp juncture, including where fingernails have undercut the keystick.Toss the blade on completion; - for the remaining surface and pore discoloration, I've tried numerous things. However, when considering costs, time involved, and minimal exposure to haz-mats, I invariably return to Parson's sudsy ammonia. At best, it removes all residual traces of dirt. At worst, it spreads everything out to provide an illusion of overall cleanliness. A working amount of the ammonia is poured out into a disposable container (paper cup, etc.) for dipping the applicator; - the applicator can be just about anything. Pre-wetting the keystick with ammonia is not required, but is sometimes an expedient on really nasty keys. If pre-wetting, use a disposable foam brush, acid brush or hammer felt scraps. For the final (might be the only) pass, a rag or shop towel works, but again considering time versus results, I use a small square </pre> </blockquote> </blockquote> <pre wrap="">of </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">fine (white) Skotch-Brite abrasive pad (aka steel wool substitute), </pre> </blockquote> </blockquote> <pre wrap="">which </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">easily rinses during use, before finally being tossed. I've also considered trying one of those nylon bath puffs, or even wadded-up pantyhose. </pre> </blockquote> </blockquote> <pre wrap="">Either </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">of these untried methods would defeat the purpose of keeping costs low (since the puffs don't lend themselves to being cut to smaller sizes, </pre> </blockquote> </blockquote> <pre wrap="">and </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">since I don't routinely have old pantyhose about). - Aside: I just heard a report that bath puffs have a slightly longer life than loufa sponges in terms of undesirable bacteria retention, and that loufa sponges are rated slightly longer than kitchen sponges, which have a service life of ... one use! Therefore, regardless of method, considering that what we're cleaning is unknown but undeniably nasty, the focus should be on expendable tools </pre> </blockquote> </blockquote> <pre wrap="">and </pre> <blockquote type="cite"> <blockquote type="cite"> <pre wrap="">materials. Jim Harvey, RPT Greenwood, SC <a class="moz-txt-link-abbreviated" href="mailto:harvey@greenwood.net">harvey@greenwood.net</a> ________________________ -- someone who's been in the field too long. _______________________________________________ caut list info: <a class="moz-txt-link-freetext" href="https://www.moypiano.com/resources/#archives">https://www.moypiano.com/resources/#archives</a> </pre> </blockquote> <pre wrap="">_______________________________________________ caut list info: <a class="moz-txt-link-freetext" href="https://www.moypiano.com/resources/#archives">https://www.moypiano.com/resources/#archives</a> </pre> </blockquote> <pre wrap=""> _______________________________________________ caut list info: <a class="moz-txt-link-freetext" href="https://www.moypiano.com/resources/#archives">https://www.moypiano.com/resources/#archives</a> </pre> </blockquote> </body> </html>