<HTML><HEAD></HEAD> <BODY style="BORDER-TOP-STYLE: none; BORDER-RIGHT-STYLE: none; BORDER= -LEFT-STYLE: none; BORDER-BOTTOM-STYLE: none"> Hey Susan...how about= a picture? David Ilvedson, RPT Pacifica, California <= BR> <DIV style="PADDING-RIGHT: 5px; PADDING-LEFT: 5px; PADDING-BOTTOM: 5p= x; BORDER-LEFT: #000000 3px solid; PADDING-TOP: 5px"> <HR> Original message From: "Susan Kline" <SKLINE@PEAK.ORG> To: "Colle= ge and University Technicians" <CAUT@PTG.ORG> Received: 2/18/2006 3:= 31:32 PM Subject: Re: [CAUT] Vertical hammer return spring slings, r= eplacement of At 04:39 PM 2/18/2006 -0400, you wrote: <BLOCKQUOTE class=cite cite="" type="cite">= If you have quite a few similar Yamahas, in your clientele.<= BR>You could buy one set, and replace the flanges= . Then in your spare time, re-cord = the ones you removed. You then have an operational set, ready to replac= e for the next time. John M. Ross</BLOCKQUOTE> Ted Sam= bell gave me a nice little jig which holds the flange at an adjustable = distance from a little pin, with another bigger post to hold a spool of= cord. Run the cord around the pin, press it into both slots, add a dro= p of CA each, then clip the end coming from the spool. Once you set it = up, the cords will all be the same length, without fiddling with all th= e short bitsy pieces. But you do have to get the flanges out and back i= n. Yes, it's easy to get the butts off the flanges when they have the p= lates, but you still have to space, etc. Susan Kline </DIV></BOD= Y></HTML>