<html> <body> Ken, Question. Does it still have the original wippens? If so, isn't this vintage teflon bushed? I know our 1972 L's are. So you might check that. One other "wild guess". Is the end of the rep spring that goes into that hole in the back of the jack too long and 'rubbing' on the jack creating a click? Good luck. Let us know what you discover. Avery Todd University of Houston At 02:31 PM 1/24/2005, you wrote: <blockquote type=cite class=cite cite="">On 1/2= 4/05 1:01 PM, "Ken Zahringer" <ZahringerK@missouri.edu> wrote: <dl> <dd>Hello, all, <dd>I’m working on a Steinway D here and it has some clicks in it that are stubbornly resisting my best efforts to eliminate them.  This is a 1970 vintage piano that has some level of action rebuild done in 1993 (before my time).  Some of this work wasn’t done particularly well, so over semester break I put new Renner shanks & flanges and Ronsen hammers on it.  It turned out very nice, but there are five notes in the low treble that click when played.  It initially sounded like the click happens at hammer impact, but I think it might be triggered by the end of keystroke.  The click seems to be in the wippen, since when I pull the action and lift the hammer out of the way, I still get a click, but if I hold the wippen up and strike the key, I get no click.  It doesn’t appear to be jack top hitting anything, but I can’t find the source of the noise.  This is particularly frustrating because I’m usually pretty good at diagnosing this sort of thing.  I’m getting this piano ready for a concert this Friday, so I’m beginning to be a little anxious.  Any experience, ideas, or wild speculations out there? <dd>Ken Z. </dl> I’ll echo Ed Foote: I’d put my money on the jack hitting something. Try reducing key dip experimentally on the offending notes, and maybe putting a wee bit of felt in the rep window. See if either or both eliminates the click. If so, you can be pretty sure the jack is, faster than the eye can see, hitting something. At any rate, I once went through an extended process of troubleshooting, similar to what you describe, certain it wasn’t the jacks, only to find out it was. Regards, Fred Sturm University of New Mexico</blockquote></body> </html>