Difficult string replacement

[PNOTNR@aol.com]

In a message dated 97-04-21 02:09:13 EDT, you write:

>Then with the t pin  that close to the,
>its called a pressure bar, not a capo bar, its a b!tch to get the
>wire thru the hole w/o a 35 $ Snap On curved nose plier. But they are
>good for getting level coils also.

If you have one of those umbrella tools that the supply houses sell for
easing damper guide bushings, you'll find that it makes a nice channel, when
inserted above the pressure bar, to guide the new wire.  (keeps the wire from
plowing through the finish on the plate as you push it through)

Gordon Large
Mt. Vernon, ME