>From: Carol Beigel <carolb@earthlink.net>
>List: I have a customer who was given a Sojin DG-1 baby grand - in pieces!
>The hardware to secure the lyre and the legs is missing. I contacted the
>local dealer and got 2 "sample" bolts. The 2 lyre bolts are a little longer
>than the leg bolts.
>
>The problem is that these bolts are non standard.
Been there, done that. Went to a local nut and bolt joint claiming to have
darn near everything in threaded material, and they never seen anything
like them leg bolts you speak of. Call Samick at 1-800-592-9393 ext. 65
(don't wait for the dumb recording, just punch in the numbers) and leave a
msg or talk with Dean. Order two longs ones, and the rest short ones.
That used to be a set for the SKG 400's but they've changed to all the same
length now.
>
>I suppose I could purchase a drill bit and tap to install standard 9/16
>bolts with a 12 thread.
Please don't. Pursue all other avenues before doing that. The T-nuts are
cast iron and should you mess up the threading process on just one, you've
got a mess on your hands trying to access the T-nuts in the keybed. It
involves removing the keybed, ............. big hammer, breaking the glue
joints after removing the screws, not a problem for an experienced
PianoDisc installer, but if you've never done this, it could be
intimidating, not to mention LOUD!!. BTW, the new T-nuts in Samick
products are cast aluminum. They cross thread really nicely. I'd imagine
after 30 years of the leg bolts (steel) reacting with the aluminum
(electrolisis I think) that either the T-nut would shatter or the threads
would crumble to little tiny pieces when the bolts are removed. Any
comments out there about this??
Lar
Larry Fisher RPT
specialist in players, retrofits, and other complicated stuff
phone 360-256-2999 or email larryf@pacifier.com
http://www.pacifier.com/~larryf/ (revised 10/96)
Beau Dahnker pianos work best under water
This PTG archive page provided courtesy of Moy Piano Service, LLC