At 12:30 AM 2/27/97 -0500, pianotech@byu.edu wrote: >I am preparing to drill a baldwin pin block without bushings and I am >wondering when drilling in the exact center of the hole if the lean of the >pin will bind at the rear of the plate hole. In other words, should I drill a >little forward of the center of the hole left by the plate? I have puzzled >this out and can't seem to come to an answer. Guess I'll just have to try one >and see. any ideas, anyone? Regards. Sam Grossner, chicago. No. Newton nhunt@jagat.com
This PTG archive page provided courtesy of Moy Piano Service, LLC