rlang wrote: > > I'm looking for some damper wires which are 0.041" diameter, 5 inches long > with a threaded end. Does anyone have any idea on how to thread a 0.041" > diameter wire or have a source for pre-threaded wire of this size. > > Many thanks. > > Bob > =========================================================================== > >>>>> Story now completely extracted like aching tooth - Charlie Chan <<<<< > rlang@netdoor.com > *** Visit my home page at http://www2.netdoor.com/~rlang *** You need to get a small die (as in tap & die) to cut the threads. Try a watch makers tools catalog or electronics supply. Look them up in the Thomas register of manufacturers at the Library to get started. You can find wire there also. Warren -- Warren D. Fisher fish@communique.net Registered Piano Technician Piano Technicians Guild New Orleans Chapter 701
This PTG archive page provided courtesy of Moy Piano Service, LLC