In a message dated 97-05-08 02:54:20 EDT, you write: << Paino is Brambach 6' baby grand. Has the double legs under the front corners and carved supports where the legs meet the keybed. I have pulled the keyslip. There are no screws in the keyframe. The fallboard does not come loose from the cheekblocks. There are no screws visable from under the piano >> Could the nameboard be attached, like some Aeolin grands, with a metal bracket screwed into a mortised side of the nameboard? Look at the ends if this is a one piece board. The screw under a rubber bumper on the cheek block. The only other one I can think of was a Chas. Ball grand that the stretcher had to be removed to expose screws in the back of the cheek block --- Talk about a hard one to try and figure out!!!! Mark Ritchie RPT Cols. OH
This PTG archive page provided courtesy of Moy Piano Service, LLC