Don, et al, I switched to exactly this method after years of old-fashioned glue sizing. The CA glue does not _seem_ to have bad side effects, so far. Best. Horace At 10:52 AM 11/19/97 -0600, you wrote: >Hi, > >I had a talk with a model airplane builder today. They frequently screw the >wings on and off their tiny models. The great problem in the past was the >screws would eventually strip. So now the screw hole is treated with very >thin CA glue. The holes wear like *iron*. After some thought, I wonder if >anyone has tried to *stabilize* balance rail holes by putting a drop of CA >glue on the (sometimes soft) wood? It might be a way to significantly extend >the life of a key not to mention stabilizing the size of the hole to avoid >humidity effects. >Regards, >Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T. >"Tuner for the Centre of the Arts" >drose@dlcwest.com >3004 Grant Rd. >REGINA, SK >S4S 5G7 >306-352-3620 or 1-888-29t-uner > > > Horace Greeley Systems Analyst/Engineer Controller's Office Stanford University email: hgreeley@leland.stanford.edu voice mail: 650.725.9062 fax: 650.725.8014
This PTG archive page provided courtesy of Moy Piano Service, LLC