I don't know.... But that's the 'standard'. It's kind of a difficult thread to get ( 3/8" by 30tpi). Most lathes won't turn it, and you have to special-order the taps and dies for it, and they are very expensive. Mike -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org] On Behalf Of Ron Nossaman Sent: Sunday, August 30, 1998 10:08 PM To: pianotech@ptg.org Subject: RE: pianotech-digest V1997 #1056 > >Not 1/8" pipe thread (tapered)? > > Ron > >The shaft and ball have a 1/8 NPT..... >The tip is 3/8" 30 TPI >Mike > Why not 1/8 NPT in the tip? Ron
This PTG archive page provided courtesy of Moy Piano Service, LLC