---------- > From: Conrad Hoffsommer <hoffsoco@martin.luther.edu> > > Hammer line had a couple of problems. Two hammers were high, and they had > lost motion. Turning adjusting screw had no "affect". Why? > Debris under wippen between wippen and wippen rail. Debris raises wippen and hammer slightly, gives "lost motion" between key and wippen so turning adjusting screw has no "affect". Been there, done that, debris probably came from snipping off old set of hammers for hammer replacement. Cure: Remove action, tilt and vacuum away debris. Also look for debris on back rail cloth under the key end. Frank Weston
This PTG archive page provided courtesy of Moy Piano Service, LLC