Rep spring jumped out of hole?? Or glue joint failed on balancier flange?? Roger At 11:10 AM 07/12/98 -0600, you wrote: >Ed, > 11:36 12/7/98 EST, you wrote: > >>Was the problem caused by the recent work? > >No. > >>Were these hammers next to each other. > >No. > >>Was it a pinning problem? > >No. > >and Avery guessed: >>Jack too low in the rep window, thereby not contacting knuckle? > >Yes. That's why there was lost motion, but why? > > > >Conrad Hoffsommer - mailto:hoffsoco@luther.edu > > Certified Calibration Technician (CCT) of > Biopowered Digitally Activated Tone Generation Systems >"If you have to plug it in, or you can't watch how it works, > I don't work on it." > Roger Jolly Baldwin Yamaha Piano Centre Saskatoon and Regina Saskatchewan, Canada. 306-665-0213 Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC