Wimblees@AOL.COM wrote: > > In a message dated 98-12-29 21:41:38 EST, you write: > > << Tonight I came back to tighten flanges and align hammers. I suspect > that the problem is that the flanges do not fit the rail properly...not > a tight enough fit. I tried every flange I had in my kit, all from > Schaff or APSCO. None of them fit very well. > > Is this just the way things are? Does no one make good replacement > flanges? > >> > > What brand is this piano. There are about three or four different flanges in > production. If you can't find one of them to fit, then perhaps it was an > oddball disign in the first place, and you do what you can with what you got. > If you want to spend the time, and the customer the money, perhaps you can > modify a flange to make it fit, and then do that to all of them. > > Wim I never heard of the brand before. It may be an oddball as you suggest. I doubt she will want to spend the $$. I'll check with her in a couple of months. -- Frank Cahill Associate Member Northern Va
This PTG archive page provided courtesy of Moy Piano Service, LLC