In a message dated 98-02-04 21:58:14 EST, you write: << Dear List, I am preparing to replace hammer return springs on a K & C compact action. Do you have any tricks or special tools in removing the old spring tails and inserting the new ones other than ordering a new rail with springs already attached? Keith A. McGavern kam544@ionet.net Registered Piano Technician Oklahoma Chapter 731 Piano Technicians Guild USA Steam old spring rail felt off and remove the springs w/pliers or hemostat. When inserting new springs, run a brass rod through the loop of each spring. This will help you line up the springs and get a tight fit. Install new spring rail felt using animal hide glue. If the previous job was used w/hide glue, you will appreciate how easily the felt will steam off. Hope this helps. Dave Peake, RPT Portland, OR
This PTG archive page provided courtesy of Moy Piano Service, LLC