At 02:04 PM 7/9/98 -0400, you wrote: >List > >Does some have a good method for cutting damper felt that yields clean, square >corners; not only on the strips, but on flat stock that come in sheets from >Renner etc. > >Paul Chick RPT >Plainview MN > Paul, I suggest that you get Bill Spurlock's damper cutting jig. It has worked great for me. I belive Pianotek sells it. Bill probably does also. You can get his address phone number out of the PTG "Resources's Book". Good luck!! Rolland Miller
This PTG archive page provided courtesy of Moy Piano Service, LLC