Considering the traffic on dummy pins and coil-making, I can't wait to see where this finger-cutting thread goes(!) 8-} At 01:23 PM 6/11/98 -0400, you wrote: >That is, if your wire was cut to four fingers. > >For advanced coil making, ie: a splice; cut the wire at three fingers >(omitting the little finger). This will allow the slack of the splice to be >drawn-up and you come out with your becket at 3:00 (+/-). Jim Harvey, RPT harvey@greenwood.net
This PTG archive page provided courtesy of Moy Piano Service, LLC