sanding block

[Kenneth W. Burton]

	Joe and Don,
	
	Chris' email address has changed. Now it is:

	cgregg@cadvision.com

	Ken Burton

On Sun, 28 Jun 1998, Joe & Penny Goss wrote:

> 
> Thanks Don. This time I put it down in the resource guide.
> Joe
> 
> ----------
> > From: Don <drose@dlcwest.com>
> > To: pianotech@ptg.org
> > Subject: Re: sanding block
> > Date: Sunday, June 28, 1998 5:01 PM
> > 
> > Hi,
> > 
> > Try Chris Gregg,cgregg@huey.cadvision.com (this may be an old email addy)
> > 
> > 
> > At 04:38 PM 6/28/98 -0600, you wrote:
> > >List,
> > >Does anyone know the name and address of the maker of the voicing
> sanding
> > >block?
> > >It has four different sides so one can sand the center string , outer
> > >string , two strings  or all so that the hammer is level to the strings.
> > >Thanks Joe Goss
> > >You know your on the level if your bubble is in the middle.
> > >
> > >
> > Regards,
> > Don Rose, B.Mus., A.M.U.S., A.MUS., R.M.T., R.P.T.
> > "Tuner for the Centre of the Arts"
> > drose@dlcwest.com
> > http://www.dlcwest.com/~drose/
> > 3004 Grant Rd.
> > REGINA, SK
> > S4S 5G7
> > 306-352-3620 or 1-888-29t-uner
> > 
>