Keith McGavern wrote: > > >...The butts have metal plates to accept > >the flange center pin which is then secured by tightening a screw... > > > > Ted Simmons > > FYI: There are Yamaha flanges that do not have the metal plates. Someone > did a technical in Orlando who specializes in the procedure of when to > replace the Yamaha flanges and when to replace just the cords. It was a > great technical! > > Does anyone remember his name, please? > Keith, Probably not the person in question but Isaac Sadigursky gave a great class at the CA State Convention wherein he talked about replacing hammer flange cords. You remove 88 hammer butts by loosening butt plates. Clean off old cords from flanges. Create proper lengths of cord by wrapping a 5/8" dowel with silk cord and cut with a razor (stroke along length of dowel). Glue one end of each length of cord to one side of each flange. Glue on other end. Reassemble. No traveling required (unless you prefer working in your shop ;-). Tom -- Thomas A. Cole RPT Santa Cruz, CA
This PTG archive page provided courtesy of Moy Piano Service, LLC