Removing grand plate drilling more holes?

[Dmsaerts@AOL.COM]

Newton wrote:
"The plate holes often are larger than the bolts.  If you are replacing
*the pin block where are you going to put it and the plate?

*If you drill two tiny (1/16") holes through the plate and through the
*pinblock you can reposition the new block and the old plate exactly when
*you measure from the old holes and use the same measurements to position
*the new block and the old plate to the new block."

*Simple and accurate.

                    Newton

Is it maybe possible to use some of the +/_ 240 holes that are pre- drilled?

 Cyrillus