In a message dated 98-09-03 01:36:26 EDT, you write: << Dear List, I am about to hang hammers using the sectional old hammer ends as a guide. My question is if I have to change the rake(angle) of the hammers to compensate for the difference of striking line on the strings. Doesn't the hammer striking line recede with the wear of the hammers? Thanks Eliot Lee >> The rake is not the problem. You need the samples to get started. Line up by using the strike point at the end of the molding as a reference. I prefer to bore my own hammers, but that is another subject. Dave Peake, RPT Portland, OR
This PTG archive page provided courtesy of Moy Piano Service, LLC