Binding Hammer Flange

[Susan Kline]

Hi, Andy

I have no idea whether this repair will last. I think I would have sized
the birdseye with glue rather than water.

However, I think your story might be redefined as a "Cautionary Tale" with
the following moral:

"Always have a good assortment of center pins in different sizes with you."

and the following closely related moral:

"Always have a good assortment of replacement flanges and hammer butts and
other action parts with you."

Best wishes,

Susan


At 12:16 AM 9/12/98 -0500, you wrote:
>Hi.
>I may or may not have solved a problem on a binding hammer flange in a
>upright player yesterday, So I thought I would put it in front of the group
>and see what you guys thought.
>
>I removed the offending hammer butt, and observed the flange. the pin was
>tuning in the butt instead of the felt bushings like it was supposed to.
>
>So I pulled the pin. eased the bushing and reinstalled the pin (I didn't
>have a bigger pin here in this case) It _still_ turned in the butt.
>
>I feared if I eased the bushing anymore I would end up with a wobbly flange,
>so I got an eyedropper, and dripped water in the pin hole in the hammer
>butt. I thought it might swell the wood just a bit and it would be tight
>again.
>
>I put the pin back in and let it set overnight. sure enough the butt was
>tight again and the pin rotated in the bushings like it should.
>
>So my question is, will this repair last or just work right until the wood
>dries out?
>
>AndyBest Regards
>Andy & Chris Taylor
>"The Lone Arranger"
>Tempola Music Rolls
>"Taylor Made" Just For You
>http://home.swbell.net/tempola/index.htm

---------------------------------------------------------------------

Susan Kline
P.O. Box 1651
Philomath, OR 97370
skline@proaxis.com