Hi All, At the risk of being disagreed with I beg to differ that the use of spring clip bridle straps reduces the technician to names muttered under the breath of someone else looking at the work. I see no reason not to use SCBS's if the catcher has no hole. If you argue that it adds mass to the action the answer is yes. If you say it is an expedient repair rather than pulling the backstops yes. If you say that it doesn't work for long periods of time and use and reduces the technician to a hack I say no. Neither does the use of cork tip bridle straps. When I first was learning all this stuff, the common method was to drill a small hole in the butt directly under the catcher dowel. We had made a little tool that the bridle strap fastened onto and we could premeasure the amount that was inserted and glued in the hole. When the glue was dry the waste ends could be clipped off. It took twice as long as using cork or spring clip tapes and in the process of trying to drill that small hole sometimes screwed up the catcher and or butt. Did that ensure that the job would last longer, no. So I am on the side that using SCBS or CTBS is just as professional as going through all the trouble of removing every catcher and doing it the long way. I wonder who decided that SPBS's was unprofessional and wrong and where was I when that was done. James Grebe R.P.T. of the P.T.G. St. Louis, MO. Competent Service since 1962 Do what is right and do no harm Creator of Handsome Hardwood Caster Cups and Practical Piano Peripherals pianoman@inlink.com
This PTG archive page provided courtesy of Moy Piano Service, LLC