The last time, an over-priced hammer checkering file (APSCO #15210F). The next time, I'll go back to the old way -- natural residuals of tail shaping with nasty grit paper on a sanding disk. Besides, this requires electricity, one of my fetishes! <g> Wanna buy an over-priced APSCO #15210F hammer checkering file...(?) At 12:42 PM 9/16/98 +0000, you wrote: > What do you use to groove/roughen the tails on a newly installed set >of grand hammers? Jim Harvey, RPT harvey@greenwood.net
This PTG archive page provided courtesy of Moy Piano Service, LLC