Well said Les. Roger At 03:24 PM 27/09/98 -0400, you wrote: > > >On Fri, 25 Sep 1998, Avery Todd wrote: > >> Hi Les, >> >> I'm going to "step in it" here and agree with both of you. I totally >> agree with what you said but if Frank DOES decide to have another go at it >> in spite of what you said :-), I agree with Susan. It's a great, legitimate >> way of getting those concrete type of hammers down to a reasonable level >> with killing yourself and the hammer by digging holes in them with needles. >> And that's about all needling would accomplish. >> I hate it when I have to agree with two people on the same post. :-) >> > >Hi, Avery: > >My post had absolutely NOTHING to do with steamimg as an approach to >dealing with rock-hard hammers and EVERYTHING to do with dealers >cutting overhead to the bone by selling disgracefully-prepped pianos to >the uninformed and foolishly trusting piano-buyer, leaving the daunt- >ing task of making these pianos right--which was HIS responsibility >in the first place-- to someone else. Further, when a competent >piano-techncian encounters such a piano and gives its owner an estimate >of what it will cost to do all the work that should have been done by >the dealer, but never was, the customer blames the TECHNICIAN for price- >gouging. After all, how can the piano possibly need that much work? Its >brand new!!! Actually, acting, or rather NOT acting, out of ignorance, >the instrument is now 2,3, or more years old and its problems--original- >ly bad enough--are now greatly compounded. > >I long ago ceased to have to take every job that came my way. I was busy >enough that I could choose which pianos I took on and which ones I didn't. >In a case like this one, I would not, but simply refer the owner back to >the dealer from whom he bought the piano originally and let him deal with >the problems which were of his making. From the way Frank describes him, >the owner of this piano and the dealer deserve each other! There are >plenty of fine-quality, meticulously-maintained pianos out there, owned >by people who know the importance of, entrust their care to, and fully >appreciate the value of, a first-class piano-technician. In all >inhumility, those are the ones I chose to work for. You should, too! > >Les Smith > >PS As far as hammer-steaming goes, it's obvious from all the fine >technicians on this list who advocate its use, that it is a valid >approach to dealing with the rock-hard hammers which one encounnters >so frequently these days. In the case above, the DEALER may want to try >steaming this piano's hammers, as well as doing all the other work it >obviously needs. ls > Roger Jolly Baldwin Yamaha Piano Centre Saskatoon and Regina Saskatchewan, Canada. 306-665-0213 Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC