Ron, I have a toolbox labeled Dampp-Chaser, but when I looked inside I found that it contains nearly all parts. The only tools in it are a small hammer, a 1/4" nut driver and an 11/32" nut driver. (This last tool is not used for normal installations.) This means that nearly all the tools I use for installations are in my normal toolcase. One tool I wouldn't want to be without is a cheap power screwdriver with a 1/4" nutdriver tip. It saves my wrist a great deal. I doubt that this information will be all that helpful. Maybe someone else will answer your question more fully. Clyde Hollinger, RPT Lititz, PA, USA Ron Torrella wrote: > > There are enough of you out there who install Dampp-Chasers on a fairly > regular basis. I wonder if you would share the content of your DC > installation toolkit - assuming you have a special box designated for > just that task - with those of us who are relative new-comers to that > facet of our work. > > Thanks in advance! > > Ron Torrella, RPT
This PTG archive page provided courtesy of Moy Piano Service, LLC