Dear Mark, If you find that you need to make your own bass dampers, I would highly recommend that you get the short technical paper on making your own bass dampers written by Bill Spurlock. The information is very inexpensive ($2.00 or $3.00), but will be very helpful to you. Also, don't forget to get the damper felt cutting blcok from Bill Spurlock... it works great! Address: Bill Spurlock Spurlock Specialty Tools 3574 Cantelow Rd. Vacaville, CA 95688 (707) 452-8564 Sincerely, David Vanderhoofven >Date: Thu, 28 Jan 1999 10:23:44 -0500 (EST) >From: Mark Graham <magraham@bw.edu> >Subject: Extra-long damper wedges >Is there a source for longer-than-usual bass damper wedges for a >one-of-a-kind vertical? Baldwin used to carry them for one of its models, >I remember, but when I called today, the woman said they don't carry >damper wedges at all. > >Will I end up making my own? I only need five for the lowest single >strings. > >Mark Graham >Baldwin-Wallace Conservatory of Music
This PTG archive page provided courtesy of Moy Piano Service, LLC