Hi Richard, YES, in a dial gauge from the supply houses. Remember they are reading net bearing and will not detect bridge roll. I use a dial gauge just for rough fast checks, and it is a handy fast INDICATOR for vertical pianos. If you want a true picture you need to use a compound bearing gauge, however a vertical has to be on a tilter to use it. Regards Roger At 10:27 PM 03/07/99 -0500, you wrote: >Is there a bearing guage that has one foot on the speaking length, the middle foot >on the bridge and the third foot adjusted to the rear termination? ric > > Roger Jolly Baldwin Yamaha Piano Centre Saskatoon and Regina Saskatchewan, Canada. 306-665-0213 Fax 652-0505
This PTG archive page provided courtesy of Moy Piano Service, LLC