In a message dated 7/26/1999 7:03:06 PM, John wrote: <<Do any of you have a good method that gives uniform backcheck heigth when reinstalling backchecks on a vertical action using a backcheck remover/installer chucked up in a drill?>> Well "good is in the eye of the beholder" :-) One method is to cut a block at the height you want the bottom of the backcheck to be..............cut a slot in in for the backcheck wire to slip into and when you are installing the new backchecks they will bottom out on the block and will all be at the same height.........works for grands and uprights............... Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC