>Canberra and to much drier conditions. Is my understanding of these pianos >correct in that this piano will start to exhibit noisy action Teflon shrinks in moisture. If it is moved to a dry climate it will tighten up. >The other is restrung (a nice job) and has had all new action components >fitted (not so good!) and is not finished and not likely to be (worse >still, it means that I will end up with this mess). The touchweight and >geometry must be wrong, I haven't had a chance to pull the action on this >one yet to take some measurements, but there is something very strange >happening here. *Very* shallow touch, aftertouch occurs at about half of >what key dip there is and touchweight is way high (Overweight hammer I >suspect). >It has an "accelerated action" (which I am only basically familiar with). I >intend to get there today to check this one out and take those measurements >and run a few string lines. I'll post any developments Key ratio. B's are notorious for this. >Any clues people? Your input will be valued, > >Thanx >Mark Bolsius > Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC