Hi Gareld, Schaff sells a Japanese made coil lifter that will get into almost any place. It is expensive by comparison but it WORKS. About $18 last time I bought one. Some technicians use a screw driver to reach in and lift the coils. I never use that technique because it always slips off the scratches the plate. That much back angle is about twice what it should be and you will likely have coils riding down until you can get the bottom one about 1/8" above the plate. I hate becketts that stick out past the pins. Too easy to get punctured and too hard to remove the coil if need be.
This PTG archive page provided courtesy of Moy Piano Service, LLC