In a message dated 11/12/1999 3:49:16 PM, Graeme wrote: <<We tend to use a worn or smaller wheel (stitched) to prevent touching the key stick.>> Graeme; If you will take a wide piece of backrail cloth, aprox 8-10 inches long, punch a capstan size hole in it, centered both ways, and then put it over the capstan, folding the strip down to where you can hold it with your fingers. This will give you protection for the keystick....better control of the buffing operation and allow you to be slightly more aggressive with your buffing.......this works well. Jim Bryant (FL)
This PTG archive page provided courtesy of Moy Piano Service, LLC