In a message dated 11/22/99 6:43:04 PM Pacific Standard Time, btrout@desupernet.net writes: << It might vary a bit, depending upon your experience, your workspace, how close the new flanges' dimensions are to the old ones' (as in how much regulation...) and a couple of other things... But I would say it would probably take somewhere in the neighborhood of 5 to 6 hours, start to finish. Just a guess since it's been quite a while since I did a set. Good luck. Brian Trout Quarryville, PA btrout@desupernet.net >> Don't forget regulation. New damper flanges will throw it off. Dave Peake, RPT Portland Chapter Oregon City, OR
This PTG archive page provided courtesy of Moy Piano Service, LLC