I will be glad when the Journal on CD, comes out. That is the chart that I recalled, but I would never have found it. That search feature on the CD will be great. I hope they inform us soon, we can order it. Or can we pre-order now? I was looking at an ad for a Loop Forming Machine, it was $32.50 net, in the March '82 Journal. The same tool in the Schaff catalogue is $28.13 today, unless it is a misprint. It is seldom a tool goes down in price. I was really surprised. Thank you all who answered. Regards, John M.Ross Windsor, Nova Scotia, Canada. ----- Original Message ----- From: "Ted Simmons" <ted@yourlink.net> To: <pianotech@ptg.org> Sent: Sunday, July 30, 2000 2:15 AM Subject: Re: Tuning Pin Torque > There is a tuning pin torque chart in the March 1982 Journal, page 9. > > ---------- > >From: Wimblees@AOL.COM > >To: pianotech@ptg.org > >Subject: Re: Tuning Pin Torque > >Date: Sat, Jul 29, 2000, 3:33PM > > > > > In a message dated 7/29/00 11:33:21 AM Pacific Daylight Time, > > piano.tech@ns.sympatico.ca writes: > > > > << Hi List, > > I was wondering, is there a table of torque measurements, > > in inch pounds, for the tuning pins. > > > > i.e. too loose? below 20 inch pounds > > loose? between 20 - 40 inch pound > > nice to tune? 40 - 80 inch pounds > > too tight? anything over 80. > > > > I remember I saw one once, but I can't remember where. > > Thanking you in advance. > > Regards, > > John M. Ross >> > > > > > > Willem Blees >
This PTG archive page provided courtesy of Moy Piano Service, LLC