In a message dated 5/28/00 7:55:51 AM Eastern Daylight Time, romanop@attglobal.net writes: << Invest in the "plastic elbow spinner" from PIANOTEK. It fits into your cordless screwdriver or chucks up into your drill. Then use a set of needle nose vise grips to hold the lifter wire and install the elbows. >> List: To even go further in simplifiying this procedure: when putting the new elbow on the lifter wire, I heat the wire with a small portable propane torch and just push the wire into the new elbow. No spinning needed just push. It cools quite quickly and you have avoided quite a bit of tedious labor. Not to mention probably saving 20 minutes of time. Just be careful you don't have an accident and burn the house down... Bob Bergantino, RPT Willoughby Hills, Ohio
This PTG archive page provided courtesy of Moy Piano Service, LLC