Solution

[Roger Jolly]

You sly old fox, this is a keeper.


At 12:14 PM 07/11/00 -0500, you wrote:
>Ok, I think it is time for me to mention my solution to the
>problem of a broken grand damper top flange screw.
>
>I will take one thin Dremel cut off wheel and cut a slot in
>the stub end of the screw and use a good miniature screw
>driver to remove the stub and then replace it with a new
>screw.
>
>The process will burn a little wood and it will heat the
>brass barrel and the screw stub which will break any bond
>between the two.  
>
>Wear safety goggles and have a good light available.
>
>Got any more ideas?
>
>		Newton
> 
Roger Jolly
Saskatoon, Canada.
306-665-0213
Fax 652-0505