Hi I insert the wire below the flange screw - this changes the centre pin relationship and jack angle Hope this helps >From: Douglasmahard@AOL.COM >Reply-To: pianotech@ptg.org >To: pianotech@ptg.org >Subject: Re: Heintzman console jack return problem. >Date: Tue, 7 Nov 2000 21:34:54 EST > >In a message dated 11/07/2000 7:51:19 PM Eastern Standard Time, >mltuner@hotmail.com writes: > ><< On some of these pianos the arc of the but is intersecting the arc of >the > jack to help this - after checking the usuall causes I've had success >simply > inserting a #22 music wire between the wippen flanges and the action >rail. > Simply loosen the flanges insert the wire and tighten the flanges - this > changed the jack position just enough to allow the jack to return - >though > at times I've had to shimm up the hammer rail as well ( as you sugest >John) > > Hope this will help you > >> >Are you inserting the wire at the bottom of the flange or at the top? > >Doug Mahard _________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com. Share information about yourself, create your own public profile at http://profiles.msn.com.
This PTG archive page provided courtesy of Moy Piano Service, LLC