Disklavier Music Support

[John Lillico, RPT]

>>  Have you ever seen the hinges bent?
>
>Bent?  Bent?  Nah, never!
>
>I have seen those hinges and have had to:
>        Replace missing hinges
>        Make missing music supports
>        Replace missing music supports
>        Replace stripped screws
>        Replace screws pulled through the metal
>        Replace the rubber "nipples"
>        Tighten perennially loosened screws
>        Replace twisted hinges
>        Straighten un straight hinges
>        Reglue split supports
>
>Bent?  Never.
>
>I had 48 Yamaha uprights from P1s to P2Bs to U1Ds and had a stock
>of hinges and graduated replacement screws.  If I had to replace
>one I replaced all 12.  I hate two or three different sizes of
>screws in a piece.
>
>                Newton

Newton, the result is just in.  Bent hinges.

Funny though! Also the two hinges appeared to be the same, there's a right and a left. I apparently put the left one on first on the right...... wrong! At least the nipples were still intact.

John Lillico, RPT
Oakville, Ontario