On Fri, 22 Sep 2000 08:04:01 -0700 "David Streit" <streit_david@hotmail.com> writes: > I'm curious as to what some of you technicians use for adjusting lost > motion in spinets. > Those square rubber/fiber grommets on the lifter wire can be a pain > in the neck and fingers especially when they crumble. ** Square grommets - Schaff Regulating tool for Kimball #60 > > What do you use for replacing a whole set? **New ones <G> John R. Fortiner Billings MT. with 4-5 " of new snow this morning >I've tried removing them > by chucking them in a fast chuck power drill and holding the lifter > wire with vice grips. While it saves the fingers, I'm not convinced > it's the fastest nor the best way. The reverse process chews up the > rubber and separates the rubber an the nut inside. > > There has got to be a better way. If anybody has one, please let me > know. > > David Streit > Associate ________________________________________________________________ YOU'RE PAYING TOO MUCH FOR THE INTERNET! Juno now offers FREE Internet Access! Try it today - there's no risk! For your FREE software, visit: http://dl.www.juno.com/get/tagj.
This PTG archive page provided courtesy of Moy Piano Service, LLC