Paul, I automatically subtract .005 from my mic readings...sorry. The reading was .034. Thanks for keeping me on my toes. David I. -----Original Message----- From: owner-pianotech@ptg.org [mailto:owner-pianotech@ptg.org]On Behalf Of Paul S. Larudee Sent: Tuesday, September 26, 2000 10:39 PM To: pianotech@ptg.org Subject: Re: Spring steel Wouldn't that be size 12.0 music wire? Paul S. Larudee, RPT Richmond, CA David Ilvedson wrote: > List, > > I need to replace a underlever spring in a Steinway M I'm rebuilding. Let's > just say it got mangled somehow...;-/. I measured the diameter at .029 or > 14.5 in piano wire. Couldn't I use this instead of spring steel, whatever > that is? I have a nifty little spring making tool I got at a chapter tool > auction and some brass spring making wire but it is a lighter gauge than the > original. Any info would be appreciated. > > David I.
This PTG archive page provided courtesy of Moy Piano Service, LLC