You ask Pianotek for a sample. I used them on the Stein M/1924 I just finished and I don't remember any unusual wobble. They do wobble some but as long as they tighten up I don't think we have a problem. David I. *********** REPLY SEPARATOR *********** On 4/14/01 at 8:45 PM A440A@AOL.COM wrote: >Inre agraffes, Paul writes: ><<If you haven't recycled the old ones yet, take out the new ones and send >them >back after making some particular measurements. Restore the old ones. >You'd >have to do the same with the new ones anyway.>> > > This piano is # 201901. A 1920 model. I replace the agraffes on >these >pianos because of the failures I have seen after restringing. I am not so >much worried about the condition of the holes as I am the structural >integrity of the brass. > And to Jim, these are definitely the 7/32" threads, they are just >.210" >instead of something closer to .219" like the old ones. > Anybody found a better supply of agraffes than the factory, or do they >all come from the same place? >Thanks, >Ed Foote RPT
This PTG archive page provided courtesy of Moy Piano Service, LLC