assist spring installation

[jolly roger]

---------------------- multipart/alternative attachment
Hi David,
              Peal about 2 inches of the woven shell back,  then clip the core
material back. Stretch the shell material and use a very thick darning needle
to thread through the holes and spring.  No glue needed. Trim with sharp
razor.
Roger


At 07:06 PM 7/31/01 -0700, you wrote: 
>
> I'm installing a set of Renner turbo wippens with assist springs and the
last
> 20 or so do not have the spring.  Renner provides a kit to do those last 20,
> if necessary, and in the case of this piano, it is.  The cord which secures
> the spring in place seems to be sized with glue to help feed it through the
> too-small-holes in the back of the flange.  Is there a special technique to
> getting that cord fed through those holes?  Once done, what is the best way
> to secure it?  And finally, what kind of glue works best for sizing the
cord 
>
>  
>  
> David Love




---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/0d/04/4f/99/attachment.htm

---------------------- multipart/alternative attachment--