oilers (Protek-good method)

[Joe & Penny Goss]

Hi Devlon,
The hole is mighty small <G>
The needle is smaller than the width of a #19 centerpin.
Joe Goss
imatunr@srvinet.com
www.mothergoosetools.com
----- Original Message -----
From: <BSHARPTUNE@AOL.COM>
To: <pianotech@ptg.org>
Sent: Saturday, August 18, 2001 10:56 AM
Subject: Re: oilers (Protek-good method)


> Joe,
>
> I checked out your site.  Good stuff!  Bought your string level in
Reno...a
> really good tool that I should have bought a long time ago.  On the oiler
> that you have though, the only problem I have had with these type is that,
> unless completely full, the fluid flows too much.  I tried the Hopps
powdered
> teflon dispenser which has a long enough needle, bottle smaller
though....had
> the same problem with flow.  If the internal barrel diameter is smaller
than
> the Hopp's or other hypo oilers, I think it would work, but that's the
> million dollar question!
>
> Thanks - Devlon