Keven, I took my Everett bracket to a welder today. He said it'a aluminum and can't be repaired. It's a castng and he called it pot metal. A freind of mine, Sam Powell RPT, says he has fixed these things with JB weld. He reinforces the bracket with brass stock. He suggested I wait until everything dries and then drill for bolts, although he didn't use bolts. So I guess this is my next step. Frank Cahill Assoc. Member Northern VA "Kevin E. Ramsey" wrote: > Regarding this posting and the one from Phil Romano; I too came upon a > broken action bracket, but on a Yamaha U1. Since it was the one on the end, > I was able to make a repair without even removing the bracket from the > rails. What I did was to go to the hardware store and get a couple of pieces > of spacer metal ( 3/4" by 2", with two holes each, probably used for > screwing two pieces of wood together, I don't know what you'd call them, > obviously). I also bought a tungsten carbide drill bit and two bolts, and a > few washers. > I repositioned the bracket pieces and marked them with a felt tip pen. > Then I drilled them for the bolts. I then mixed up some JB weld, applying it > to both parts, and clamped the whole thing together tightly. I then laid the > action down on a flat bench to get the angle exactly the same as the other > brackets, and let it set overnight. Put it back in the piano, and everything > worked just great, no regulation needed, just what I was going to do to it > anyway, before I started on this job. > I was doing this for one of the salesmen whom I work with who had just > bought this piano, used, so I was reshaping hammers, voicing, and regulating > it anyway. But I didn't notice the break in the action bracket until I put > it in the cradle. I'll be looking for this sort of thing in the future, > though. > > Kevin E. Ramsey > ramsey@extremezone.com > ----- Original Message ----- > From: "Frank/Anne/Emily Cahill" <fcahill@erols.com> > To: <pianotech@ptg.org> > Sent: Wednesday, July 18, 2001 4:56 AM > Subject: action brackets > > > I am working on an Everett console. > > > > I have a broken action bracket...clean break. > > > > Can this be repaired? > > > > Does anyone have an old bracket for sale? (The bracket is 8 3/8" tall.) > > > > Frank Cahill Associate Member > > Northern VA
This PTG archive page provided courtesy of Moy Piano Service, LLC