Agraffe Wrench

[David Love]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
Thanks for the suggestion Del.  I will probably have to do something =
like this.  I will admit, tool making is not a favorite past time.  I'd =
much rather buy. =20

David Love
  ----- Original Message -----=20
  From: Delwin D Fandrich=20
  To: pianotech@ptg.org=20
  Sent: July 20, 2001 10:22 AM
  Subject: Re: Agraffe Wrench


  Carefully measure the width and height of the agraffe extension and =
pay a visit to your local machine shop. Have him/her cut an appropriate =
slot in the end of a 1/2" steel rod and mill a square or hex -- your =
choice -- on the other end. If this is a tool you'll be using from time =
to time you might want him/her to harden it a bit.

  -- ddf=20
-------------------------------------------------------------------------=
-----

    ----- Original Message -----=20
    From: David Love=20
    To: Pianotech=20
    Sent: July 19, 2094 11:07 PM
    Subject: Agraffe Wrench


    Any of you tool makers out there have an agraffe wrench that will =
accommodate a .220" deep agraffe?

    Please reply on or off list.

    David Love

    davidlovepianos@earthlink.net



---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/9e/50/15/b9/attachment.htm

---------------------- multipart/alternative attachment--