This message is in MIME format. Since your mail reader does not understand this format, some or all of this message may not be legible. ---------------------- multipart/alternative attachment Hi Phil - As previously suggested, I have done 3-4 of these using a cardboard model to get the dimensions just right, then using 3/4 inch plywood and a bandsaw to cut a new one. Not as bad as you might think, but does take a bit of patience with the cardboard model. So far, all of the ones I have done have required slightly different dimensions, so one size does not fit all, to be sure. Good luck... Mark Potter bases-loaded@juno.com On Sun, 22 Jul 2001 17:52:44 -0400 "Phil Romano" <romanop@attglobal.net> writes: Hi List, I have need of the lever that is pushed by the fall assembly and causes the music desk to open. It is for a Hallet and Davis 54" upright # 96155 circa 1917. Does anyone have one lying around the shop? Please email me privately if you would be willing to part with it. What is the name of this lever? It's not in Mason's book. Phil Romano Myrtle Beach, SC philromano@attglobal.net ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/a8/d8/4a/24/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC