flat tabletop

[Paul]

Joe
Good idea. The bolts are machined with hex flats, but access through the top
with a screw driver would make it simpler to adjust.
Thanks!

Paul Chick
----- Original Message -----
From: Joe & Penny Goss <imatunr@primenet.com>
To: <pianotech@ptg.org>
Sent: Wednesday, February 28, 2001 10:27 PM
Subject: Re: flat tabletop


> Paul
> Sounds good to me The bolts would have plenty of surface, You might
consider
> cutting a slit in the end of the bolt so that it could be turned with a
> screw driver.
> Joe Goss
> imatunr@primenet.com
> http://www.primenet.com/~imatunr/
>